Sort by:
Snap Ring Kit, Remove and Install Kit (Select Options)
$118.31 – $845.60
To displace & remove snap ring: Tooling is designed to be bolted to your work bench The holes in the back of the base tooling will displace the collar from...
Snap Ring Positioner Delco
$31.58
Notes:
Application: 10MT
Quickly installs the snap ring in the exact position in the groove
Shipping Rates:
Estimator works for USA shipping only.International shipping rates are calculated during checkout
Snap Ring Removing Tool
$145.00
Notes: Our new Snap Ring Remover removes most snap rings. Snap Rings have always been a favorite part of the rebuilding process. They are probably the biggest cause of self-inflicted...
Specialty Bearing Pusher
$2,900.00
This Bearing Pusher is an essential tool for safely and effectively removing bearings from Denso Alternator Rotors. This precision tool is designed to push the rotor away from the bearing...
Speed Lathe - Air-Collet Closure
$7,495.00
Air-Collet Closure: The air-collet closure is designed and built as an integral element of the speed lathe. Therefore, low speed restriction or cylinder wobble is NOT inherent in Crozier speed lathes....
Speed Lathe - Standard Chuck
$7,995.00
The unit is small enough to fit on a table. The chuck is a standard six inch design. The jaws are two piece for doing both ID and OD work....
Standard Tips - Pair
$35.00
Notes:
For use with: G304-0052 and G304-0052-T Welders
Shipping Rates:
Estimator works for USA shipping only.International shipping rates are calculated during checkout
Stator Pulling Kit Screw Type - Kit - (Make Selection)
$95.77 – $957.66
Complete Kit Includes (1 Bolt, 11 Plates):M158-0108-AS1 2.73" Industrial,M158-0108-AS2 3.01" Nippondenso Internal Fan 14684- 14937- 14843- Etc.,M158-0108-AS3 3.24" Nippondenso Internal Fan - 15757- 14671- Etc.,M158-0108-AS4 3.53" Nippondenso Internal Fan- 14611- 14679- 14680- Etc.,M158-0108-AS5 3.60" Nippondenso/Chrysler-...
Steel Shot Blaster Basket 6" x 6"
$375.00
Notes: These baskets are designed to be rugged enough to use in a steel shot blaster, but you can also use these in a shaker. Specifications: Diameter: 6.00" Length: 6.00"...
Tailstock Chuck, 3 Ball Bearing - for #2 Morse Taper
$345.00
Notes: Scroll action allow easy closing from about 1"to import bushing size on a starter armature Not designed for 6000 bearing range 3/8"to 1"capacity Shipping Rates: Estimator works for USA...
Tap .669-20
$88.00
Shipping Rates:
Estimator works for USA shipping only.International shipping rates are calculated during checkout
Thread Die Round .669-20
$35.00
Specifications:
Die OD:
1 1/2"
Shipping Rated:
Estimator works for USA shipping only.International shipping rates are calculated during checkout